How-to

Residential RV Pad Planning Guide

An RV pad is not a wide walkway. It's the most heavily loaded slab most homeowners will ever pour — a parked RV concentrates enormous weight on a few small contact patches and leaves it there for months. Slabs built like patios fail under that. Here's what a real RV pad requires.

Load first: the spec follows the vehicle

Start with one honest number: the loaded weight of the biggest rig that will ever park there — not the one you own today. That number sets the thickness and the reinforcement. A pad for a small travel trailer and a pad for a loaded Class A are different structures that happen to look alike. This is why "how thick are your RV pads?" has no one answer, and why a bid quoted before anyone asks about your rig is a guess. Load-driven thickness is one of the plain cost drivers — more depth and steel cost more, and should.

The base carries everything

Under sustained point loads, base failures that a driveway would shrug off become visible fast. The base needs uniform compaction across the whole pad, and — this being Fresno — protection from water. Much of the area's ground is loam over a cemented hardpan that water can't pass through; a pad base that saturates every winter settles under a parked rig, and a settled RV pad tilts the vehicle and cracks the slab. The slope plan is what keeps the base dry: water off the pad, away from the house, to a stated destination, in writing before the pour.

Access and approach

Three practical details bids often skip:

  • The approach. The transition from street or driveway onto the pad takes the same loads as the pad. A thin apron at the entry is where cheap pads crack first.
  • Turning geometry. Can the rig actually get onto the pad? Swing radius, gate width, and overhang have surprised more than one finished project.
  • Hookups and slope. If you'll run power or water to the pad, conduit goes in before concrete. And RVs want to park close to level — the pad's drainage fall has to be planned so water leaves while the rig sits comfortably. Those two requirements can be reconciled, but only on paper, in advance.

The checklist

  • Loaded vehicle weight stated in the scope
  • Thickness and reinforcement matched to it
  • Base compaction and slope plan in writing
  • Approach apron built to pad spec, not walkway spec
  • Conduit and clearances decided before pour day

That's the standard on our walkways, sidewalks & RV pads page. The fit & requirements FAQ covers what we need from you to spec it, and if you're weighing surface options, concrete vs. pavers explains why point loads favor a slab.

Ready to see where your water goes?

Request a free on-site estimate. Jose walks your lot, reads the slope, and gives you a written plan before anything is poured. No pressure, no obligation.

(559) 206-3347 · communionconcrete@outlook.com · By appointment, Friday–Sunday